Even in the optimal case, when the structure is straight, the drums are correctly set and the belt runs in the centre, misalignment can still be a problem.

The belt can run into the structure and get cut and damaged, the material falls down, increasing the amount of the losses. The belt needs to be changed more frequently and you have to check and reset the belt continually.

Why do you need to give up so much time and money, if the misalignment can be solved?! The concept of the usual solutions was to apply a force onto the edge of the belt, to push it back to centre, but they didn't last long, and were not always efficient.

With our patented method the belt runs in the centre, and you will have more time for other important tasks. The result is proven and we give you a guarantee for it! If you are not satisfied with the result, we give you back your money!

The solution is the Tru Trac belt guide roller (patented), which has to be tensioned to the belt. It does not rely on the contact with the belt edge, so avoids damaging it. With the help of a vertical central pivot axis inside, through a horizontal movement it activates immediately if the belt begins to drift off centre.

Before the problematic area, in most cases to the return side, before the tail pulley.

For 50 m conveyor length 1 roller is enough, In case of longer belts, you need to put one for about every 50 m of the structure.

No maintenance is needed. Depending on the use, the lifetime is about 3 years after that you have to change the bearings.